Super Flower Power Supplies

↪ Notes: Hold-up time fails to meet the ATX minimum specification.

↪ Notes: 850W has weak 3.3V transient response, but otherwise works well. 1000W seems to lack proper efficiency certifications, but meets gold criteria.

↪ Notes: The OCP triggering points should be reduced on all rails, especially the minor rails. Good component quality.

↪ Notes: 1200W hold-up time fails to meet the ATX minimum specification.

↪ Notes: Initial testing from 2024 showed 5VSB OCP was set too high leading to failure of the unit. The unit was retested in June 2025 and passed.

↪ Notes: 230V only since 115VAC sockets cannot supply 2kW of power.

↪ Notes: Pro version - black casing instead of white. Pigtail PCIe cables for the 650W. Cost down version of the Pro ARGB.

↪ Notes: Poorly tuned OCP & OPP, 20AWG pigtails on PCIe connectors. 750/850w has a dual 8 pin to 600W 12VHPWR cable available for purchase.

↪ Notes: Chinese caps, 20AWG gauges on the EPS/PCIe cables; 5VSB regulation doesn't quite hit A tier specifications.

↪ Notes: Poorly tuned OCP triggering points and 20 gauge wire for the far-end PCIe connectors. Treat capacity as ~100W lower than advertised.

↪ Notes: Unusually tight OCP triggering points and 20 gauge wire for the far-end PCIe connectors. Treat capacity as ~100W lower than advertised.

↪ Notes: OCP on 3.3V rail is not properly implemented.

↪ Notes: 1300W 5VSB voltage regulation doesn't quite hit A tier performance.

↪ Notes: White variant available at 1kW.

↪ Notes: Bridgeless PFC, exceptional electrical performance per Cybenetics' entry & confirmed internal shots per Quasar Zone and Aris.

↪ Notes: No transient response testing found.

↪ Notes: Limited information.

↪ Notes: Semi-modular/costdown Combat FG. Does not seemingly suffer the same SCP issue with the FG.

↪ Notes: Cybenetics report says 650W and 850W units died in -12V SCP testing, which is no longer used in modern systems. 750W unsubmitted.

↪ Notes: Ripple is too high for tier A. Otherwise, the unit performs well. The OCP triggering points should be reduced on all rails. Good component quality.

↪ Notes: Rifle bearing fan, 85C bulk cap.

↪ Notes: Leadex II costdown, single-layer PCB. Sleeve bearing fan. Capacitors aren't of the highest quality.

↪ Notes: No OTP and OCP (12V) present; low hold-up time (out of spec); poor soldering quality.

↪ Notes: Group regulated.

↪ Notes: Sleeve-bearing fan. OCP untested.

↪ Notes: OCP doesn't work properly on +12V, unit experiences a huge voltage drop to 10.92V on +12V. Avoid until further testing.